Bridge Saws and Diamond Granite Saws

Model ETC36 Granite monument Bridge Saw & Slant Saw

The ETC36 Bridge Saw (or slant saw) features an all steel beam bridge design, heavy-duty stands, direct drive, 20 HP motor, electronic controls and 36” diamond tipped blade with a sawing length of 12 feet.  The motor runs along a 12” square tubing main beam with 1/4” X 2” metal wear strips on the top of the bridge. 6’ x 8' Turntable included.  Used for sawing joints on granite slabs & beveled granite markers and can be uses for sawing granite countertop slabs.

ETC36 Granite Bridge Saw Specifications

This machine is built by the Elberton Tool Company, Inc and Rice Industrial Electric.
Power of main motor: (20 HP) Direct Drive Motor (220V 3 phase 40Amp.)
Engine rotating speed 1450 RPM, Step Cutting, Cutting speed variable.
12' Sawing Length.
Saw is automatic with Plunge Cut & Amp Trip Shutdown.
Ball Screw lifts with Rubber Billows.
8" Square Tubing Uprights.
12" Square Tubing Main Beam with 1/4" x 2" Metal Wear Strips on Main Beam.
6' x 8'  Turntable with Marker Rack on cart for easy sawing.
Brake Motor on Raise & Lower, Delta Drive Variable Speed Carriage.
Including Delivery & Installation
 

ETC5 Granite Chop Saw

The ETC5 Granite Chop Saw built by the Elberton Tool Company, Inc and Rice Industrial Electric is used to cut granite blocks at any angle. Saw head rotates 180 degrees to make cutting difficult angles an easy task.  5’ x 5’ work table with air lift and locks.

See specifications below.

ETC Granite Chop Saw Specifications

5' Sawing Length.
8" Square Tubing Uprights.
8" Square Tubing Main Beam.
Chop Saw has 180 degrees of Tilt Left & Right.
Manual Pendant Control for "Hands Free" operation
Machine Carriage & Blade for Safety
5' x 5' Turntable with Air Lift & Locks.
5 H.P Main Motor.
Linear Actuator on Raise & Lower Angle of Head.
Up & Down , Carriage & Cart or Variable Speed Delta Drive.

Primary Uses: Cutting Notches, Double Harts and Inside V-Cuts at all Angles in granite monuments.